YLJ-HP80 Pneumatic Lamination Hot Press with Precision Pressure Control, 9 kN Force, 200×150 mm Heating Plates, up to 150°C
The YLJ-HP80 is engineered to facilitate precise lamination and pressure testing tasks commonly required in solid-state battery research and electrode fabrication. It enables controlled application of pneumatic pressure combined with accurate temperature regulation, making it suitable for processes such as SEI layer formation and electrode lamination under hot pressing conditions.
This press is compatible with inert gas atmospheres and can be integrated into glovebox setups, supporting research environments that require oxygen- and moisture-free conditions. The pneumatic system is driven by standard air compressors or inert gas cylinders, with necessary pressure regulation to ensure safe and stable operation.
Key Features
- Maximum pressing force of 9 kN with a pneumatic cylinder bore diameter of 125 mm.
- Heating plates measuring 200 mm by 150 mm with independent PID temperature controllers for each plate.
- Temperature range up to 200°C with ±1°C accuracy and a maximum heating rate of 10°C per minute.
- Pressure controller with PID tuning and ±0.5 kg/cm² pressure accuracy, programmable in 30 segments with up to 9999 minutes per segment.
- Working height adjustable from 0 to 110 mm and pneumatic cylinder travel distance up to 200 mm.
- Compatible with argon gas and suitable for glovebox integration with optional feed-throughs for gas and electrical connections.
- CE approved; NRTL or CSA certification available upon request.
Technical Specifications
| Parameter | Specification |
|---|---|
| Max. Load | 9 kN (900 kgf) |
| Pneumatic Cylinder Bore Diameter | 125 mm |
| Cylinder Travel Distance | 200 mm max. |
| Working Area (Heating Plates) | 200 mm W x 150 mm D |
| Max. Working Height | 0 – 110 mm adjustable |
| Max. Temperature | 200°C continuous |
| Temperature Control | Single point PID, ±1°C accuracy |
| Heating Rate | Up to 10°C/min |
| Power Supply | 208-240 V AC, 50/60 Hz, 1200 W, single phase |
| Pressure Controller | Digital PID with ±0.5 kg/cm² accuracy, 30 programmable segments |
| Air/Gas Supply Pressure | 0.4 – 0.8 MPa (from air compressor or inert gas cylinder) |
Typical Applications
The YLJ-HP80 is ideal for testing the influence of pressure on solid-state battery performance, including SEI layer formation and electrode lamination processes. It is also used as a jig for compressing adjustable split test cells such as coin cells and pouch cells, especially in inert atmospheres.
Configuration & Operating Notes
The press requires an external air compressor or inert gas cylinder for pneumatic actuation; these are not included. When using a gas cylinder, a two-stage pressure regulator must be installed to maintain safe operating pressure. For glovebox integration, optional feed-throughs for gas lines and electrical connections are available but not included in the standard package.
Periodic calibration of applied pressure using a NIST-certified load cell is recommended to ensure accuracy. Alignment of the upper and bottom plates can be fine-tuned via adjustable screws at the corners.
