MSK-T-10 Carbon Steel Replacement Cutting Die Set with Various Dimensions for Precision Sample Preparation
The MSK-T-10 cutting die set is engineered for laboratory applications requiring precise cutting of samples with consistent dimensions. It addresses the need for interchangeable dies in various sizes to accommodate different experimental protocols and sample geometries. This die set is essential for users who require reliable and repeatable cutting performance in sample preparation workflows.
Each die set consists of a matched upper and lower die pair made from carbon steel, a material chosen for its durability and cutting precision. Due to the carbon steel composition, the dies are sensitive to moisture and must be kept dry and clean to maintain their integrity and performance. Proper maintenance includes cleaning with ethanol or alcohol after use and thorough drying to prevent corrosion.
Wichtigste Merkmale
- Available in various dimensions to meet diverse experimental cutting needs.
- Manufactured from carbon steel for precise and durable cutting edges.
- Upper and lower dies sold only as matched pairs to ensure exact fitting and alignment.
- Requires careful handling and moisture control to prevent rust and damage.
- Cleaning recommended with ethanol or alcohol after each use to avoid cross-contamination.
- Installation requires matching part numbers of pushing rod and bottom plate for compatibility.
- Precision design demands careful installation to avoid misalignment and die damage.
Technische Daten
| Parameter | Spezifikation |
|---|---|
| Material | Carbon Steel |
| Abmessungen | Various sizes available; select per experimental requirements |
| Configuration | Upper and lower die sold as matched pairs only |
| Maintenance | Clean with ethanol/alcohol after use; dry thoroughly |
| Compatibility Check | Ensure pushing rod and bottom plate part numbers match before installation |
Typische Anwendungsbereiche
Used in laboratory presses and cutting instruments for preparing samples with precise dimensions. Suitable for research and development environments where repeatable and accurate cutting is critical, such as battery electrode fabrication, material science, and powder metallurgy.
Hinweise zur Konfiguration und zum Betrieb
The MSK-T-10 die sets must be installed as matched pairs to ensure proper alignment and avoid damage. Users should verify that the part numbers of the pushing rod and bottom plate correspond to the die set to guarantee compatibility. Due to the minimal tolerance in precision dies, careful handling during installation and operation is essential. Misalignment or improper installation can cause die damage and is not covered by manufacturer liability. It is recommended to have multiple cutters with pre-installed dies to facilitate efficient workflow and reduce downtime.
