MSK-119 3-In-1 Edge Ironing, Trimming and Folding Machine for Large Pouch Battery Casings with Adjustable Temperature and Continuous Workflow

The MSK-119 is engineered to streamline the finishing process of large pouch cell battery casings by integrating three critical operations—edge trimming, folding, and ironing—into a single continuous workflow. This machine addresses the common challenge of uneven and excess casing edges after pouch cell fabrication, ensuring a professional, smooth, and tidy finish essential for pilot-scale battery production lines.

Operators manually load the pouch cells onto the machine’s linear sliding rail, which facilitates easy manipulation through the sequential modules. The trimming module first removes excess casing material with a high precision of ±0.1 mm, preparing the edge for subsequent folding and ironing. The ironing module applies adjustable heat up to 250°C and controlled dwell time to smooth the edges before and after folding, which partially folds the casing edge to secure it neatly. This multi-step process results in a finished pouch cell casing with commercial-grade edge quality.

Wichtigste Merkmale

• Three integrated modules for trimming, folding, and ironing in one continuous operation.
• Adjustable ironing temperature range from room temperature up to 250°C.
• Dwell time adjustable between 1 and 20 seconds for precise edge smoothing.
• High trimming accuracy within ±0.1 mm and blade lifespan of approximately 1 million cycles.
• Supports pouch cell dimensions: length 20–350 mm, width 10–150 mm, thickness 4–12 mm.
• Requires compressed air supply at 0.7–0.8 MPa; air compressor not included.
• Manual loading with linear sliding rail for ergonomic operation.

Technische Daten

Typische Anwendungsbereiche

The MSK-119 is primarily used in pilot-scale production lines for pouch cell batteries, where precise edge finishing is critical to product quality. It is suitable for battery research and development facilities and small-scale manufacturing setups requiring consistent trimming, folding, and ironing of large pouch battery casings.

Hinweise zur Konfiguration und zum Betrieb

The machine requires an external compressed air source operating between 0.7 and 0.8 MPa; the air compressor is not included and must be sourced separately. When using a gas cylinder instead of an air compressor, a two-stage pressure regulator must be installed to maintain safe operating pressure. The linear sliding rail facilitates manual loading and movement of the battery holding fixture through the trimming, folding, and ironing modules. Operators should follow the prescribed sequence to ensure optimal edge quality: trimming excess casing, initial ironing, folding edges, and final ironing for a neat finish.

Maße & Versand