SPC-2030-RR Automatic Roll to Roll Screen Printing System with Infrared Drying Oven
The SPC-2030-RR is engineered to facilitate precise screen printing on flexible substrates using a roll to roll mechanism. It is particularly suited for research and pilot production of flexible batteries, fuel cells, OLEDs, and other electronic devices requiring uniform thin film deposition. The system accommodates substrate widths from 5 to 200 mm and prints on sheets up to 200 mm wide by 300 mm long with high positional accuracy.
This automatic system integrates four main components: a roll to roll transport mechanism with tension control, a screen printing unit capable of handling screen frames up to 230 mm by 380 mm, an infrared drying oven with temperature control up to 150ºC, and a PLC-based touch screen for precise process control. The intermittent movement of the substrate allows for accurate layer deposition and drying in a continuous workflow.
Wichtigste Merkmale
- Roll to roll printing with intermittent substrate movement and tension control for consistent material handling.
- Maximum printing area per sheet of 200 mm (W) x 300 mm (L) with positional accuracy of ±0.1 mm.
- Infrared drying oven capable of heating up to 150ºC with ±5ºC temperature accuracy to ensure rapid curing.
- Scraper speed adjustable from 0 to 20 cycles per minute to accommodate various slurry viscosities.
- PLC touch screen control for setting substrate speed, intermittent running length, and cycle counts.
- Supports slurry viscosities ranging from 5 to 100,000 cps, manually applied.
- CE certified with optional NRTL or CSA certification available upon request.
Technische Daten
| Parameter | Spezifikation |
|---|---|
| Maximum Screen Frame Dimension | 230 mm (W) x 380 mm (L) |
| Maximum Printing Area per Sheet | 200 mm (W) x 300 mm (L) |
| Scraper Speed | 0 – 20 cycles per minute |
| Positioning Accuracy | ± 0.1 mm |
| Viskositätsbereich der Aufschlämmung | 5 – 100,000 cps |
| Substrate Width | 5 – 200 mm |
| Printing Width | 5 – 195 mm |
| Roll to Roll Movement Speed | 0.1 – 7 m/min (adjustable) |
| Winding Roller Size | 38 mm Diameter x 200 mm Width |
| Infrared Oven Maximum Temperature | 150ºC |
| Oven Length | 600 mm |
| Oven Temperature Accuracy | ± 5ºC |
| Stromversorgung | 208 – 240 V, Single Phase, 50/60 Hz |
| Gesamtstromverbrauch | 5500 W |
| Compressed Air Requirement | 0.5 – 0.6 MPa (compressed air pump not included) |
Typische Anwendungsbereiche
The SPC-2030-RR is ideal for pilot-scale production and R&D of flexible electronic devices such as flexible batteries, fuel cells, OLED displays, and other thin-film electronic components requiring precise layer deposition and controlled drying.
Hinweise zur Konfiguration und zum Betrieb
The system requires manual slurry application and a compressed air supply at 0.5 to 0.6 MPa for operation; the compressed air pump is not included and must be sourced separately. The PLC touch screen interface allows operators to adjust substrate speed, intermittent movement parameters, and drying conditions for optimized process control. Optional certifications such as NRTL or CSA can be requested at additional cost.
