YLJ-HP60-LD Hydraulic Hot Lamination Press with 6T Force and 120x120mm Heated Platens up to 200°C
The YLJ-HP60-LD is engineered for precise lamination processes essential in the fabrication of electrodes and electrolytes for solid-state and flexible lithium batteries. This compact hydraulic hot press applies controlled heat and pressure to materials within a 120 mm by 120 mm platen area, enabling uniform lamination and bonding critical for battery component integrity.
Equipped with two aluminum alloy platens embedded with heating elements, the device reaches temperatures up to 200°C for short durations (under 30 minutes) and maintains continuous operation at 100°C. Temperature is regulated via a digital controller with ±1°C accuracy. The hydraulic system delivers a maximum pressing force of 6 metric tons, with a maximum platen opening of 30 mm, allowing accommodation of various sample thicknesses.
Key Features
- Dual heated platens (120×120 mm) made of aluminum alloy with embedded heating elements.
- Digital temperature control up to 200°C with ±1°C accuracy.
- Hydraulic pressing force up to 6 metric tons for effective lamination pressure.
- Maximum platen opening of 30 mm to accommodate various sample sizes.
- Power supply options: 110VAC or 220VAC ±10%, single-phase, 50/60Hz.
- Optional upgrade to digital pressure gauge available for precise force monitoring.
- CE certified with UL/CSA certification available upon request.
Technical Specifications
| Parameter | Specification |
|---|---|
| Model | YLJ-HP60-LD |
| Heated Platen Area | 120 mm × 120 mm |
| Platen Material | Aluminum alloy with embedded heating element |
| Maximum Working Temperature | 200°C (max 30 minutes), 100°C continuous |
| Temperature Control | Digital controller, single set point, ±1°C accuracy |
| Maximum Working Pressure | 6 metric tons |
| Maximum Platen Opening | 30 mm |
| Power Supply | 110VAC or 220VAC ±10%, 50/60Hz, single-phase |
| Power Consumption | 1200 W max, 15A circuit breaker required |
Typical Applications
This hot lamination press is primarily used in battery research and development laboratories for preparing electrodes and electrolytes in solid-state and flexible lithium battery manufacturing. It is suitable for lamination tasks requiring precise temperature and pressure control to ensure material integrity and performance.
Configuration & Operating Notes
The press base must be securely mounted on a stable, immovable table before operation to ensure safety and optimal performance. Users should avoid pressing small-area dies directly against the soft aluminum platen surfaces; adding hard steel plates on both top and bottom is recommended for such applications. An optional digital pressure gauge upgrade is available for enhanced force measurement accuracy. CE certification is standard; UL/CSA certification can be provided upon request at additional cost.
